Ball carbon cold curve dating fusion

Bottle physical characteristic definitions are included on the General Bottle Morphology page as well as below in Click on the pictures to enlarge and on the hyperlinks - where available - for more information and/or a picture or illustration elsewhere within this website.

Names in bold italics are specifically covered elsewhere on this page if a user is unsure about the meaning or definition.

- An early - probably the first - thermosetting plastic which made its debut in 1927 as a screw cap closure material though was first patented in 1907 (Berge 1980).

ball carbon cold curve dating fusion-74

What differentiates the applied finish from the tooled finish is the separate application of glass to the neck end; this was not done in the process that produces the tooled finish discussed below.

The process of "applying" a finish usually results in some amount of excess glass "dripping" down below the bottom edge of the finish, as shown in the picture to the right.

(aka "mold air venting") - Small vent holes in a bottle mold which release pressure and gases from the mold while the bottle is being blown or expanded.

Vent holes usually leave small glass "dots" or bumps on the body and sometimes the base of the finished bottle which are typically slightly smaller than a pin-head in size.

A somewhat stylized, "typical" bottle is illustrated on the following page: General Bottle Morphology.

Most of the "parts" of a bottle are easier to visualize than describe.See the applied finish section of the Bottle Finishes & Closures main page for more information.NOTE: The author of this website has prepared a summary of the mouth-blown bottle finishing methods section on the Bottle Finishes & Closures page which is available as a downloadable and printable (pdf) article entitled: "The Finishing Touch: A Primer on Mouth-blown Bottle Finishing Methods with an Emphasis on "Applied" vs.White's 1978 work on bottle nomenclature published in Historical Archaeology, since this journal article is widely accepted and referenced by historic archaeologists.(Not every term from his list is repeated on this list; only those deemed pertinent).- That part of a toggle closure device which is connected to the lever wire and passes over the lid holding it in place on the bottle or jar. A bail is easier to define with a picture than to describe.

Tags: , ,